Changes between Version 25 and Version 26 of Eucalyptus-1.5.2-Setup

Show
Ignore:
Timestamp:
02/06/10 00:42:06 (9 years ago)
Author:
ibaldin (IP: 98.26.55.18)
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • Eucalyptus-1.5.2-Setup

    v25 v26  
    1212You will need several hosts with dual interfaces - one interface on 'management' network and one on 'data plane' that will be stitched into ORCA slices. At RENCI this setup is implemented by having each host its eth1 on BEN management network (192.168.xx.xx address space) and eth0 connected into BEN with unassigned IP addresses. 
    1313 
    14 Each host should support hardware virtualization and be able to run kvm. The cluster will consist of a single head node and multiple compute nodes. The head node requires substantial disk space to store all VM filesystem images (if you plan to support many options). The head node can also act as a compute node and instantiate VMs on itself. These instructions however presume that the head node is not performing this function. 
     14Each host should support hardware virtualization and be able to run kvm. The cluster will consist of a single head node and multiple compute nodes. The head node requires substantial disk space to store all VM filesystem images (if you plan to support many options).  
    1515 
    1616The dataplane interfaces of the cluster should be plugged in into an ORCA-controllable switch (a Cisco 6509 in our case) to allow for the mapping of Euca-created vlans to other vlan segments.