Changes between Version 7 and Version 8 of Eucalyptus-1.5.2-Setup

Show
Ignore:
Timestamp:
02/04/10 22:47:34 (9 years ago)
Author:
ibaldin (IP: 98.26.55.18)
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • Eucalyptus-1.5.2-Setup

    v7 v8  
    1919  
    2020 1. Ubuntu jaunty basic server install 
    21  1. kvm and libvirt (including libvirt-bin) 
     21 1. kvm and libvirt (including libvirt-bin). Ubuntu favors kvm over Xen. KVM requires hardware virtualization support in your CPU! 
    2222 1. ntp (Euca instructions suggest using open-ntp, however there is no reason not to use the Ubuntu 9.04 stock ntpd3 server 
    2323 1. vconfig tools (to enable creating tagged interface) 
     
    4040$ brctl show  
    4141}}} 
    42  1. [CN] Make sure kvm is OK: 
     42 1. [CN] Make sure kvm is OK. If you receive a message about a problem with a kernel module either your CPU does not support hardware virtualization, or it is disabled in the BIOS. In the latter case, edit the BIOS setting and try again: 
    4343{{{ 
    4444$ /etc/init.d/kvm restart 
     
    5656        bridge_stp off 
    5757        bridge_maxwait 0 
    58 }}} to /etc/network/interfaces. NOTE: in this setup eth0 is the dataplane interface facing into BEN. It remains unconfigured. The management interface is eth1 and is not shown here - it has a static configuration. Restart networking and verify that br0 and eth0 are in the UP state. Verify that bridge br0 exists and eth0 is part of it: 
     58}}}  
     59to /etc/network/interfaces. NOTE: in this setup eth0 is the dataplane interface facing into BEN. It remains unconfigured. The management interface is eth1 and is not shown here - it has a static configuration. Restart networking and verify that bridge br0 exists and eth0 is part of it, verify that br0 and eth0 are in the UP: 
    5960{{{ 
    6061$ brctl show 
     62$ ifconfig br0 
     63$ ifconfig eth0 
    6164}}} 
     65Refer to the discussion [http://open.eucalyptus.com/wiki/EucalyptusNetworking_v1.5.2 here] about the significance of having the correct bridge setup.  
    6266 
     67=== Installing Eucalyptus === 
    6368 
     69Follow the instructions [http://open.eucalyptus.com/wiki/EucalyptusInstallationUbuntuJaunty_v1.5.2 here]. Be sure to select the right packages for your architecture. BEN cluster uses amd64 packages for eucalyptus and euca2ools.  
    6470 
     71=== Configuring Eucalyptus === 
     72 
     73We will configure Euca to run in MANAGED network mode to enable dynamic VLAN creation. 
    6574 
    6675= Undoing an install =