Changes between Version 70 and Version 71 of Eucalyptus-2.0-Setup

Show
Ignore:
Timestamp:
09/30/10 17:31:26 (9 years ago)
Author:
ibaldin (IP: 152.54.9.21)
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • Eucalyptus-2.0-Setup

    v70 v71  
    112112}}} 
    113113 * Make sure master node has dhcpd installed (typically /usr/sbin/dhcpd or /usr/sbin/dhcpd3). It must not be configured. The worker nodes '''cannot''' deal with multiple DHCP servers on the same subnet in this Eucalyptus mode. The only DHCP server on that subnet must be the one used by Eucalyptus. It is important to know if DHCPD needs to be run as user root or dhcpd. '''Apparmor, if running, may need to be configured to allow dhcpd to read/write files from custom locations (e.g. $EUCALYPTUS/var/run/eucalyptus/net ). ''' 
    114  * Read [http://open.eucalyptus.com/wiki/EucalyptusNetworkConfiguration_v2.0 networking configuration notes]. Examples here presume master node has a single interface (eth1) that is both public (allows anyone to reach the host) and is used to communicate to the rest of the cluster. Your setup may be different.  
     114 * Read [http://open.eucalyptus.com/wiki/EucalyptusNetworkConfiguration_v2.0 networking configuration notes]. Examples here presume master node has a single interface (eth1) that is both public (allows anyone to reach the host) and is used to communicate to the rest of the cluster, while worker nodes use bridge named 'eth1'. Your setup '''will''' be different.  
    115115 * Modify the configuration of the master node ($EUCALYPTUS/etc/eucalyptus/eucalyptus.conf; only the relevant stanzas are shown; make sure no other VNET_MODE statements are uncommented in the file). Note that in the shown configuration the 10.100.x.x range is used internally by Eucalyptus, while 192.168.203.x range is 'public' (even though it comes from a reserved address space): 
    116116{{{