Changes between Version 1 and Version 2 of xcat-neuca-worker

Show
Ignore:
Timestamp:
02/25/11 12:33:44 (8 years ago)
Author:
ibaldin (IP: 152.54.9.21)
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • xcat-neuca-worker

    v1 v2  
    1818 Id Name                 State 
    1919---------------------------------- 
     20# 
     21}}} 
     22 *Make sure bridge named 'br0' is created at boot time. This is separate from virbr0 created by libvirt by default. br0 needs to carry the management IP address of the node and eth0 should be a member of this bridge: 
     23{{{ 
     24 
     25# ifconfig br0 
     26br0       Link encap:Ethernet  HWaddr 00:1D:09:29:FF:DA   
     27          inet addr:192.168.201.43  Bcast:192.168.201.255  Mask:255.255.255.0 
     28          inet6 addr: fe80::21d:9ff:fe29:ffda/64 Scope:Link 
     29          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1 
     30          RX packets:7621193 errors:0 dropped:0 overruns:0 frame:0 
     31          TX packets:1793760 errors:0 dropped:0 overruns:0 carrier:0 
     32          collisions:0 txqueuelen:0  
     33          RX bytes:9385876051 (8.7 GiB)  TX bytes:680733217 (649.1 MiB) 
     34# [root@euca-c1 libvirt]# brctl show 
     35bridge name     bridge id               STP enabled     interfaces 
     36br0             8000.001d0929ffda       no              eth0 
     37virbr0          8000.000000000000       yes 
    2038}}} 
    2139 *